FINALLY… A Comfortable, Narrow, Performance Handle Bar for HD Street Glide Models !!!
At FXR Division, we Blended the T Bar Feel and Wrist Angle of our FXR Division Motorwitch Bars and made these for ALL Street Glide Models (2008 and Earlier would require Upgrading to the 2009 and Newer Brembo Style Master Cylinder)…
The MOST NARROW Street Glide Specific Handlebars in the Industry… And made to the same HIGH STANDARDS with BEST Materials available !!! These bars allow FULL Use of your Factory Gauges and Navigation/Media Center WITHOUT ANY MODIFICATIONS!!!
The FXR Division Streetwitch Bars for Street Glides measure and Impressively Narrow 33” from end to end… You won’t look or feel like a kite flying down the road and your hands will not be protruding WAY outside your fairing !!!
The only way to have a more narrow bar on your Street Glide is to go with an Offset Plate and a set of our FXR Division Split Angle or FXR Division Split MX Bars.
Like our Split MX, Split Angle, and G Series Bars… we manufacture these IN HOUSE out of 1.250 X .125 steel tubing, we make sure to debur ALL material inside and out prior to welding for the smoothest wire pulls, and like ALL of our FXR Division Bars, are Throttle By Wire READY…YES… Your OEM Throttle By Wire fits PERFECTLY!!!
ALL FXR Division Handle Bars are finished in a High Quality Gloss Black Powder Coat (CHROME IS NOT AVAILABLE AS IT HAS BECOME TOO EXPENSIVE AND DIFFICULT TO QUALITY CONTROL) … Our customers have been purchasing our FXR Division Bars and Crash bars in Black and having them stripped and plated locally to them)
Streetwitch measurement are from the base inline to mid grip.
** If your OEM Perch Clamp has a locating pin… it will be necessary to remove it before installation**
*** Don't forget to get a set of NEW Gooden-Tite FLT Handlebar Bushings to go with your bars!***
****We normally DO NOT stock bars over 16”… they are Made To Order and may take a little bit longer to manufacture and ship… Orders for Bars over 16” WILL BE subject to a 20% Cancellation Fee if order is cancelled after 7 Days from the Date the Order was placed***
We do our best to have ALL of Our FXR Division bars IN STOCK. However, if they are not immediately available… then they are currently IN PRODUCTION.
If do not receive a Shipping Notification, with your tracking number within 1-3 business days… Then please allow 2-4 weeks for orders to ship.
ALL FXR DIVISION PARTS ARE PROUDLY MADE AND MANUFACTURED IN THE USA.
Pre-Wire Service
Don't want to hassle with pulling your harnesses through your handlebars? We will take care of that! Our pre-wire service will make the job that much easier. This service includes new Guerrilla Cables harnesses to plug right into your switch packs. There is will also be a "fishing line" ran through right side of handlebar so that you can easily pull your twist grip sensor. We look forward to seeing you hit the road with your new handlebar set-up.
